7-5
Configuring IP Addressing
IP Configuration
Configuring IP Addressing
■If you change the IP address through either Telnet access or the web
browser interface, the connection to the switch will be lost. You can
reconnect by either restarting Telnet with the new IP address or entering
the new address as the URL in your web browser.
IP Addressing in a Stacking Environment
If you are installing the switch into an HP Procurve stack management
environment, entering an IP address may not be required. See “HP Procurve
Stack Management” on page 13-1 for more information.
Menu: Configuring IP Address, Gateway, and Time-To-Live (TTL)
Do one of the following:
■To manually enter an IP address, subnet mask, set the IP Config parameter
to Manual and then manually enter the IP address and subnet mask values
you want for the switch.
■To use DHCP or Bootp, use the menu interface to ensure that the IP Config
parameter is set to DHCP/Bootp, then refer to “DHCP/Bootp Operation” on
page 7-10.
To Configure IP Addressing.
1. From the Main Menu, Select.
2. Switch Configuration ...
5. IP Configuration
Note If multiple VLANs are configured, a screen showing all VLANs appears instead
of the following screen.