Jackson 200B, 200S Specification Information, Operating Capacities, Performance/Capabilities

SECTION 1: SPECIFICATION INFORMATION

OPERATING CAPACITIES
PERFORMANCE/CAPABILITIES		ELECTRICAL REQUIREMENTS
OPERATING CAPACITY (RACKS/HOUR)		WASH PUMP MOTOR HP							1
RACKS PER HOUR	57
DISHES PER HOUR	1425	NOTE: Typical Electrical Circuit is based upon (1) 125% of
GLASSES PER HOUR	1425	the full amperage load of the machine and (2) typical fixed-
		trip circuit breaker sizes as listed in the NEC 2002 Edition.
OPERATING CYCLE (SECONDS)		Local codes may require more stringent protection than
		what is displayed here. Always verify with your electrical
WASH TIME	45	service contractor that your circuit protection is adequate
RINSE TIME	11	and meets all applicable national and local codes. These
TOTAL CYCLE	58	numbers are provided in this manual simply for reference
TANK CAPACITY (GALLONS)		and may change without notice at any given time.
						RINSE			TYPICAL
WASH TANK (MINIMUM)	8.0	MODEL	VOLTS PH		HZ	HEATER	TOTAL		ELECTRICAL
BOOSTER TANK	3.0					RATINGS	AMPS		CIRCUIT
		200B	208	1	60	12KW@230	72 A		90 AMP
WASH PUMP CAPACITY		200B	230	1	60	12KW@230	79 A		100 AMP
		200B	208	3	60	12KW@230	40 A		50 AMP
GALLONS PER MINUTE	150	200B	230	3	60	12KW@230	44 A		60 AMP
		200B	460	3	60	12KW@230	22 A		25 AMP
TEMPERATURES		200B	208	1	60	14KW@230	79 A		100 AMP
		200B	230	1	60	14KW@230	87 A		110 AMP
WASH---°F (MINIMUM)	150	200B	208	3	60	14KW@230	44 A		60 AMP
RINSE---°F (MINIMUM)	180	200B	230	3	60	14KW@230	49 A		70 AMP
WASH---°F (MINIMUM) (200 LT)	130	200B	460	3	60	14KW@230	25 A		36 AMP
RINSE---°F (MINIMUM) (200 LT)	130	200	208	1	60	N/A	29 A		40 AMP
NOTE: Always refer to the machine data plate for specific		200	230	1	60	N/A	31 A		40 AMP
		200	208	3	60	N/A	15 A		20 AMP
electrical and water requirements. The material provided on		200	230	3	60	N/A	16 A		20 AMP
this page is for reference only and may be	subject to	200	460	3	60	N/A	8	A	15 AMP
change without notice.		200/LT	208	1	60	N/A	29 A		40 AMP
STEAM REQUIREMENTS		200/LT	230	1	60	N/A	31 A		40 AMP
		200/LT	208	3	60	N/A	15 A		20 AMP
COIL SIZE	3/4”	200/LT	230	3	60	N/A	16 A		20 AMP
		200/LT	460	3	60	N/A	8	A	15 AMP
STEAM FLOW PRESSURE (P.S.I.)	10-20
CONSUMPTION @ 15 P.S.I. (LBS/HR)	45	200S	208	1	60	N/A	7	A	15 AMP
WATER REQUIREMENTS (MINIMUM)		200S	230	1	60	N/A	7	A	15 AMP
		200S	208	3	60	N/A	4	A	15 AMP
INLET TEMPERATURE (200)	180°F	200S	230	3	60	N/A	4	A	15 AMP
		200S	460	3	60	N/A	4	A	15 AMP
INLET TEMPERATURE (200B)(40° Rise)	140°F
INLET TEMPERATURE (200B)(70° Rise)	110°F
INLET TEMPERATURE (200LT)	140°F
INLET TEMPERATURE (200S)	110°F
GALLONS PER HOUR	52.2
GALLONS PER RACK	0.92
WATER LINE SIZE NPT	3/4”
DRAIN LINE SIZE NPT	1 1/2”
FLOW PRESSURE P.S.I. (Optimum)	20A5
MINIMUM CHLORINE REQUIRED (PPM)(200LT)	50

200 Series Technical Manual

7610-100-45-00 Rev. E (02/10/2006)

2