SECTION 2: INSTALLATION/OPERATION INSTRUCTIONS
STRIKER PLATE LIMIT SWITCH INSTALLATION INSTRUCTIONS
Installation Instructions:
1.Wiring: The switch is wired common and nor- mally open because of the hinge design. By interrupting the line in series with the door switches, the dishmachine ceases to operate. Refer to the machine schematic for details on how to wire the switch.
1/3 RACK WIDTH
2.Parts of the table switch are mounted in the dishtable, at the end of the table and under the table. See the drawing(s) for the relationship of the switch to the table.
3.Move the limit switch as far down on the two slots as possible and see that the limit switch is straight on the base plate. This might require adjustment of the nut on the connector for the limit switch.
4.Then adjust the inside and the outside con- nector nuts for the connector box so that it lines up even with the limit switch and the base plate.
5.Tighten down the nuts for the seal so that they are tight.
TABLE LIMIT SWITCH THROUGH ROD HOLES
TABLE
SWITCH RODS
STRIKE PLATE
STRIKE PLATE BOLTS
INSTALL AT FAR END OF TABLE
6.If you have any difficulty you might have to adjust the connectors to the seal, screwing in or screwing out until the installation is straight on the table and the limit switch is actuated correctly by the rack.
MOUNTING BOLTS
TABLE BOTTOM
Ø0.75 
Ø0.25
Unless noted, all dimensions are in inches.
3.00 |
2.00 |
1.875
1.50
TABLE BOTTOM
Issued:
51
