JBL 260 user manual Mono DLY 20 MS 810 ms Unused Select Link/Unlink

			Section 3
DriveRack	®
		Configuration Functions

•You are now in the Crossover module. The upper left-hand corner of the display indicates what Crossover type is currently selected. Rotate the DATA wheel to select the Crossover type. The letters ‘A’ or ‘B’ to the left of the crossover indicate a mono crossover, ‘A+B’ indicates a mono summed crossover, and the letters ‘ST” indicate a stereo crossover. Pressing and then rotating the DATA wheel lets you select the route path (i.e. which inputs will be routed to the selected Crossover module). You can route either Input A, Input B or a sum of the Inputs (A+B) to any mono input crossover. As previously mentioned, a stereo crossover selection is indicated with the letters ‘ST’ (use this selection when you want to use a stereo in/stereo out configuration). Use the PREV PG and NEXT PG buttons to move through Outputs 1-6, configuring Crossover modules as necessary, and then to the next module screen which will appear something like this:

POST EQ

Link/Unlink

P2

P2

P3

P4

P5

P6

•You are now in the Post-Crossover PEQ module. Rotate the DATA wheel to link and unlink these output PEQ modules as desired. Use the PREV PG and NEXT PG buttons to move through outputs 1-6, linking and unlinking modules as desired, and then to the next module screen which will appear something like this:

LIMITER

Select Link/Unlink

L2

L2

L3

L4

L5

L6

•You are now in the Post-Crossover Dynamics module. The upper left-hand corner of the display indicates what Dynamics processor type is currently selected (i.e. Limiter or AGC). Rotate the DATA wheel to select the Dynamics processor type. Pressing and then rotating the DATA wheel lets you link or unlink these Dynamics modules. Note that you can only link like type Dynamics modules. Use the PREV PG and NEXT PG buttons to move through outputs 1-6, selecting and linking/unlinking these modules as necessary, and then to the next module screen which will appear something like this:

MONO DLY 20 MS 810 ms Unused Select Link/Unlink

D2

D2

D3

D4

D5

D6

•You are now in the Output (Post-Crossover) Delay module. The upper left-hand corner of the display indicates how much delay time is currently allocated to this module. The

1-6 Output indicators indicate which Output Delay module you have selected. Rotate the DATA wheel to set how much delay time will be available to the selected Output Delay module. Note that the actual delay time is not set at this point; the delay time can be set

DriveRack® User Manual 25