JBL 260 user manual DriveRack, Section, Power Up Modes

			Section 5
DriveRack	®
		Utilities/Meters

To set the PUP Program option use the following procedure:

•From Program mode, press the UTILITY button and use the PREV PG or NEXT PG buttons to move to the page that appears as follows:

Power Up Modes
PUP Program	Stored
PUP Mute	Current

•With the arrow next to the PUP Program option, turn the DATA wheel to make the desired selection.

To change the PUP Mute setup, use the following procedure:

•From Program mode, press the UTILITY button and use the PREV PG or NEXT PG button to move to the page that appears as follows:

Power Up Modes
PUP Program	Stored
PUP Mute	Current

•Select the PUP Mute option by pressing the DATA wheel until PUP Mute is selected. Once the PUP Mute option has been selected, proceed to rotate the DATA wheel until the desired mute setting is selected. To exit, press the PROGRAM/CONFIG button.

5.1.3 ZC Setup

A unique feature of the DriveRack 260 is its ability to interface with dbx proprietary Zone Controller wall-panels. This feature gives you the ability to control various parameters of the 260 such as Output Levels, Mute and Program Changes. Up to six ZC panels can be connected to a DriveRack 260. To program a ZC panel, proceed with the following instructions.

•From Program mode, press the UTILITY button and use the PREV PG or NEXT PG button to move to the page that appears as follows:

ZC Setup
Panel 1	None

(STORE) - EDIT PANEL

Important Note: The dip switches on the ZC panel(s) must match the Panel (ID) number displayed in this page.

DriveRack® User Manual 41