JBL 260 user manual DriveRack, Section, Configuration Functions, A A2, Cna Fcb, Da Db

Section 3
		DriveRack
		®
	Configuration Functions

•You are now in the Pre-Crossover EQ module. The upper left-hand corner of the display indicates what EQ type is currently selected. The A and B indicators indicate which input is currently selected. Rotate the DATA wheel to select either the 9-band Parametric EQ (PEQ) or 28 band Graphic EQ (GEQ). Pressing and then rotating the DATA wheel lets you link or unlink the input EQ modules as desired. Note that the same EQ types must be selected to link. If you plan to use the Auto EQ feature, you must select a GEQ type EQ here. Use the PREV PG and NEXT PG buttons to move through A and B and then to the next module screen which will appear something like this:

COMP

Select Link/Unlink

C N A F C B

12

•You are now in the Pre-Crossover Insert module. The upper left-hand corner of the display indicates what Insert type is currently selected. The A and B indicators indicate which input is currently selected. The 1 and 2 indicators indicate which module block is currently selected (i.e. Insert 1 or Insert 2). Rotate the DATA wheel to select either Wire (no effect), AGC, Compressor, AFS, Noise Gate or Subharmonic Synthesizer. Pressing and then rotating the DATA wheel lets you link or unlink the A and B modules. Note that the same Effect types must be selected to link. Use the PREV PG and NEXT PG buttons to move through A and B, 1 and 2 and then to the next module screen which will appear something like this:

MONO DLY 1.3 10 ms Unused Select Link/Unlink

D A D B

•You are now in the Input (Pre-Crossover) Delay module. The upper left-hand corner of the display indicates how much delay time is currently allocated to this module. The A and B indicators indicate which input is currently selected. Rotate the DATA wheel to set how much delay time will be available to the selected Input Delay module. Note that the actual delay time is not set at this point; the delay time can be set once you have exited Configuration mode. Pressing and then rotating the DATA wheel lets you link or unlink the Input Delay modules as desired. Use the PREV PG and NEXT PG buttons to move through A and B, and then to the next module screen which will appear something like this:

1X1 FILTER

Select

Route

A A 2 2

BA 3 4 A A 5 6

24 DriveRack® User Manual