JBL 260 DriveRack, Section, Configuration Functions, Saving Configuration Changes, 34 56

Section 3
		DriveRack
		®
	Configuration Functions

once you have exited Configuration mode. Pressing and then rotating the DATA wheel lets you link or unlink the Output Delay modules as desired. Use the PREV PG and NEXT PG buttons to move through outputs 1-6, allocating delay and linking/unlinking modules as necessary, then to the next module screen which will appear something like this:

OUTPUT CH2

Route

NAME Output Ch2

<STORE>-EDIT NAME

2 2

34

5 6

•You are now in the Output Route and Naming module. The arrow indicates whether you can change the Routing or change the Name of the output. The output 1-6 indicators indicate which Output module block is currently selected. Rotate the DATA wheel to change the Output Route. Pressing the DATA wheel in, then allows you to rename the output. Turning the DATA wheel will allow you to select a predetermined name. Pressing the STORE button will move you to the Naming Page which appears something like the following display:

NAME: Output Ch2

<DATA> - SELECT CHARACTER <PREV/NEXTPG> - LEFT/RIGHT <STORE>-EDIT/<UTIL>-EXIT

•Turn the DATA wheel to change the selected character. Pressing the DATA wheel in successively allows you to toggle between uppercase letters, lowercase letters, numbers, and symbols/blank space. The PREV PG and NEXT PG buttons allow you to move to the next or previous character (left and right). Once all of the naming assignments have been made, press the UTILITY button to return to Configuration mode. Use

the PREV PG and NEXT PG buttons to move through outputs 1-6, re-routing and renaming outputs as necessary, until you reach the next page. The display will now read ‘CONFIGURATION DONE’. If you have made all necessary changes, press the DATA wheel to load these changes into your program. If you decide that you do not want to load these changes, you can press and hold the CONFIG button until the display reads ‘Abort Config’. Either way you will now be back in Program Edit mode.

Important Note! You must navigate to the last page within Configuration mode and load the new configuration (by pressing the DATA wheel) for any changes in Configuration mode to take effect.

3.6 Saving Configuration Changes

Once your Configuration edits have been loaded, these new changes can be saved. Please see section 3.4 ‘Saving Factory Program Changes’ for information on how to store and rename the program. You can then make necessary processing parameter changes (i.e. crossover, EQ, Delay adjustments, etc.).

26 DriveRack® User Manual