JBL 260 user manual DriveRack, 2 4 2 2 4, Section, Remote Control, ZC-1& ZC-2, ZC-3, ZC-4

			SECTION 6
DriveRack	®
		Remote Control

ZC-1 & ZC-2

1.Select the ‘Panel’ number (this must match the Dip Switch setting (ID#) set on the ZC

	wall panel).	1.
2.	Select a ZC-1 (or ZC-2 if using a ZC-2) as	3.
	the ‘Type’.
3.	Set the maximum amount of ‘Boost’ that will	5.
	be applied (0 dB typical).

4.Set the maximum amount of ‘Cut’ that will be applied (40 dB typical).

5.Select which ‘Output(s)’ you would like this ZC to control.

ZC-3

1.Select the ‘Panel’ number (this must match the Dip Switch setting (ID#) set on the ZC

wall panel).	1.
2. Select a ZC-3 as the ‘Type’.	3.

3.Select which ‘Program’ will be loaded when selecting each corresponding position (A-D) on the ZC wall panel.

ZC-4

1.Select the ‘Panel’ number (this must match the Dip Switch setting (ID#) set on the

	ZC-4).	1.
2.	Select a ZC-4 as the ‘Type’.	3.

3.Select which ‘Switch Combination’ (binary #) you would like to program.

4.After the correct Switch Combination number is selected, select which ‘Program’ will be loaded when this Switch Combination is triggered from the custom switches, which are connected to the ZC-4.

Repeat steps 3 and 4 for all remaining Switch Combinations.

2.

4.

2.

2.

4.

DriveRack® User Manual 55