JBL 260 DriveRack, Section, Remote Control, Zone Controller Wiring, Diagram A Diagram B, Wa Tts

SECTION 6
		DriveRack
		®
	Remote Control

ZONE CONTROLLER WIRING

The DriveRack 260 Zone Controllers, (ZC-1, ZC-2, ZC-3, ZC-4) can be wired serially or in parallel. To wire in series each Zone Controller must have an identification or zone number chosen using the DIP switches on the side of the controller (see diagram A). Each controller must have a unique number chosen, although there may be multiple Zone Controllers controlling a single zone, or a single Zone Controller that controls multiple outputs. The Zone Controllers can then be wired together and connected to the DriveRack 260 (see diagram B).

The Zone Controllers may also be wired in parallel with the use of the ZC-BOB. To wire in parallel (home run cabling), each controller must have a unique identification or number chosen using the DIP switches on the rear of the panel (see diagram A). It is good practice to match the ID # of each ZC with the corresponding numbered port on the ZC-BOB. To wire in parallel, each controller must be wired into a port of the ZC-BOB with a connecting wire going to the DriveRack 260 (see diagram C).

Diagram A

Diagram B

ID# 1	ID# 4
80-1342- A	80-1342- A
UL-650 0	UL-650 0

IEC6006

IEC6006

18 WA TTS

A HARMAN INTERNA

TIONAL

5

5

COMP ANY SAL T LAKE

CITY

, U TA H

MADE IN USA

MODEL

DriveRack

TM 260

RJ45

ONLYCONNECTTO CONTROLLERZONE UTPNI .

RJ45

ONLYCONNECTTO CONTROLLERZONE UTPNI .

Employer uniquement avao

POWER

COMPLETE

E Q & LOUDSPEAKER

MANAGEMENT

SYSTEM

Use only with a 250V fuse

un fusible de 250V

100V -120V

50/60H z

PC

ZON E C ONTROLLER

CH 6

56 DriveRack® User Manual