Jenn-Air FCG20100, FCG20510 manual TO replace light bulb, Carefully unscrew the glass light lens

Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker

panel Be sure that the entire oven cavity including the light bulb is cool before attempting to remove.

TO replace light bulb:

1.Carefully unscrew the glass light lens.

2.To obtain firm grasp on bulb, wear protective rubber gloves.

light bulb with a dampcloth as bulb will break. Note: If the bulb does break and you wish to remove it, be certain power supply is disconnected and wear protective gloves. You

may contact your authorized Jenn-Air Service Contractor for

Remove by turning bulb to the left. Do not tough a hot oven _[ service.

3.Replace bulb with a 40 watt oven-rated appliance bulb. Bulb with brass base is recommended to prevent fusing of bulb into socket.

4.Replace bulb cover and reconnect power to oven. Reset clock.

Before replacing light bulb, DISCONNECT POWER TO RANGE.

To replace fluorescent surface light: Grasp the top of backguard with thumbs under front edge and gently pull outward while lifting to release trim from catches at each end.

Remove bulb and replace with an 18 watt fluorescent tube. Snap top tdm back into place, restore power and reset clock.

TOPTRIMOF

BACKGUARD FLUORESCENTTUBE

36