Jenn-Air WW2750 Other Hints on Caring for Your Oven, Cleaning Other Surfaces of Your Oven, Racks

Other Hints on Caring for

Your Oven

Cleaning Other Surfaces of Your Oven

Door and control panel trim: The metal trim around the door and the control panel can be clean_

with any nonabrasive cleansers such as Bon-Ami or soapy water; rinse well. Be careful not to use excessive amount of water.

Control panel and oven door front: To clean, use any suitable glass cleaner or soapy water. prevent moisture from getting behind the control panel, spray a c[oth with glass cleaner then wipe t panel

Con trol knobs: The knobs on the control panel can be removed with the controls in the OFF positk PUI) each knob straight from the shaft. Wash knobs in warm soapy water or dishwasher; do not t. abrasive cleansers or materials. To replace each knob, match flat part of knob opening with the epri

on the shaft, returning		in OFF position.	.._
To remove	pull forward	to the "stop" pesi-	'_
finn; lift up	on the front	of the rack and pull
out.
Oven	Racks	Bulb	"
Oven	Light

Before replacing bulb, disconnect power to oven at the main fuse or circuit breaker panel. Be sure the entire oven cavity including the light bulb is cool before attempting to remove,

To replace	light	bulb:		I _I'',	"'
1. Carefot_y remove the giaes tight			lens and lens	_	I
retainer	by removing the two screws		in the light lens
retainer	using a phillips screwdriver.		Note: Thei}ght
tens ieseparate		from the light Sensretainer. The two
pieces will drop down into your hands at the same
time. Do NOT remove the remaining two $crewa.

2.To obtain firm grasp on bulb, wear protective rubber gloves Remove by turning bulb to the left, Do not touch a hot oven light bulb with a damp cloth as bulb

willshbreakto .remoNOTE:ve it,(f bethe cebulbrtaindoespowbreakersupplyand youis		\_I\,	',_	i
dieconnectedandwearprotectivegtoves.	You may
contact your authorized Jean-Air Semice	Contrac-
tor for service.

3.Replace bulb with a 40 wattoven-ratedappfiance

bulb. Bulb with brass base is recommended to		--_'_r_	I
prevent fusing of bulb into socket.
4. Plaeelightlensinsideoflightiensretainer.	Hotding
the light lens and lens retainer in place, insert the
two screws into the light tens retainer and tighten.
	28