Jenn-Air W2720, W2450B, WW2750, WM2720, WM2750, W2410 To change STOP TIME before cleaning begins

To check STOP TIME: Hold in STOP TIME button until the words STOP TIM

appear in the Display Window. The stop time will be displayed briefly, then Display w return to on-going program.

To change STOP TIME before cleaning begins:

1. Hold in STOP TIME button until words STOP TIME appear in the Display Windo

2.Turn SET dial to desired STOP TIME.

3.Push ENTER button to enter new stop time.

NOTE: If more than 7 seconds elapse between holding in START TIME button STOP TIME button and turning the SET dial, the displaywindow will automatica return to on-going program.

NOTE: Ifmore than 1minute elapses between turning SET dialto a new time a entering new START TIME and STOP TIME, the entire program will be cancel and display will retum to time of day clock.

To stop cleaning process before lock indicator light comes on:

1.Move the DOOR LOCK LEVER to the left.

(NOTE W2410 and WW2460 OWNERS: Omit this step.)

2.Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.

3.Push CANCEL button twice.

To stop cleaning process after lock indicator light comes on:

1. Push CANCEL button twice.

2.Leave the TEMPERATURE and SELECTOR knobs in the CLEAN position,

3.Allow oven to cool until the LOCK INDICATOR LIGHT goes out. This may tak_ to 45 minutes, depending on how long the oven has been on.

4. After LOCK INDICATOR LIGHT goes off, move the DOOR LOCK LEVER to the (NOTE W2410 and WW2460 OWNERS: Door will automatically unlock at the of cool down time.)

5.Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF,

NOTE: When SELECTOR knob is turned to CLEAN, a fan comes on. If this f_ is notoperating, the ovenwill gothrough the self-cleaning process at a reduced or, temperature and the oven will not clean effectively. If the fan does not opera1 contact your Jenn-AirAuthorized Service Contractor for service.

26