GF 100 DV II Nordic QT
GF 200 DV II Lillehammer
Optional Blower # 155631
CONNECT THE GAS SUPPLY TO THE
STOVE BEFORE INSTALLING THIS
BLOWER. USE A 90° ELBOW OFF THE
GAS VALVE TO CREATE ADEQUATE
GAS LINE CLEARANCE.
THIS BLOWER MUST BE |
ELECTRICALLY GROUNDED IN |
ACCORDANCE WITH LOCAL CODES |
Contents
1.Blower
2.Snapstat Wire Harness
3.Control Box
4.Snapstat Bracket
5.Rheostat Knob
6.Snapstat
7.Mounting Bracket (GF100 DV II ONLY)
8.M6 Flange Nuts, (2)
9.M6 x 12 Hex Bolts, (2)
10.#8 x 1/2” Sheet metal screw, (4)
Tools Required
•1/4” socket driver
•10 mm socket driver or wrench
OR, IN THE ABSENCE OF LOCAL |
CODES, WITH THE CURRENT ANSI/ |
NFPA 70, NATIONAL ELECTRICAL |
CODE OR CSA |
ELECTRICAL CODE. |
THIS UNIT IS SUPPLIED WITH A |
FOR PROTECTION AGAINST SHOCK |
HAZARD AND SHOULD BE PLUGGED |
DIRECTLY INTO A PROPERLY |
GROUNDED |
RECEPTACLE. DO NOT CUT OR |
REMOVE THE GROUNDING PRONG |
FROM THE PLUG. |
ALWAYS DISCONNECT THE POWER |
SUPPLY WHEN PERFORMING ANY SERVICE ON THE FIREPLACE INSERT.
|
|
|
| 10 |
|
|
|
| 7 |
Upper Holes |
|
|
|
|
for GF100 |
|
|
|
|
DV II |
|
|
|
|
Lower Holes | 4 | 6 |
|
|
|
|
| ||
for GF200 |
|
|
|
|
DV II |
|
|
| 10 |
|
|
|
| |
10 |
|
|
|
|
|
| 2 | 1 | 9 |
|
|
|
|
53 8
Figure 35. Blower Kit Components
Installation
1.Unpack and check the con- tents of the blower kit. Con- tact your dealer if any damage is evident or parts are missing. See fig. 35.
2.Attach the Control Box to the Snapstat Bracket using two #8 x 1/2” sheet metal screws. As shown in fig. 35, use the pair of mounting holes appro- priate for your stove.
3.Attach the Control Box to the studs located underneath the stove in the middle of the firebox floor using the two M6 hex nuts and a 10 mm socket driver or wrench. See fig. 36.
MANUAL
Snapstat
OFF
AUTO
BLOWER
Secure with
two Hex Head
Flange Nuts
Figure 36. Attach Control Switch Box.
24
