Jotul GF 400 DV manual Vent Termination Zones - Propane, Vertical Termination for COLINEAR VENT

Vent Termination Zones - Propane

	35 Ft.
(10.67 m)
			Horizontal and Vertical
	30 Ft.	Terminations for COAXIAL VENT
	(9.14 m)
				Up to four 45° or
				two 90° elbows
	25 Ft.			permitted in
				addition to the
	(7.62 m)			starter elbow.
RUN		A
VERTICAL	20 Ft.	B
	(6.10 m)
	15 Ft.
	(4.57 m)
	12 Ft.			D
	(3.65 m)
		B
	8 Ft.
	(2.43 m)
	5 Ft.
	(1.52 m)	OPEN AIR INLET
	Min. Rise	RESTRICTOR
	2 Ft.
	(.60 m)
		5 Ft.	10 Ft.	15 Ft.	20 Ft.	27 Ft.
		(1.52 m)	(3.05 m)	(4.57 m)	(6.09 m)	(8.22m)

HORIZONTAL RUN

•VENTING MUST TERMINATE (END) WITHIN ONE OF THE DESIG- NATED AREAS. ZONE “A” IS FOR VERTICAL TEMINATIONS ONLY.

•SET STOVE EXHAUST RESTRICTOR TO THE POSITION THAT CORRE- SPONDS TO THE VENT TERMINATION AREA IN THE DIAGRAM ABOVE.

•OPEN AIR INLET RESTRICTOR FOR TERMINATIONS 5 FT AND UNDER. SEE FIG. 6, PAGE 9.

•ALWAYS MAINTAIN THE PROPER CLEARANCES TO COMBUSTIBLES.

The circled letter designations in the vent diagram correspond to the Exhaust Restrictor Setting on the stove. First, determine which vent termination zone is appropriate for your installa- tion and fuel type, then adjust the stove restrictor plate to the corresponding position as shown in Figure 7, page 9.

Figure 11. Coaxial Vent Termination Window / LP

Vertical

Termination for

COLINEAR VENT

35Ft.

(10.67 m)

RUN
VERTICAL	25 Ft.

(7.62 m)

C

D

Minimum

Vertical

Termination

8Ft.

(2.43 m)

2 Ft.

(16 cm)

•VENTING MUST TERMINATE (END) WITHIN THE SHADED AREA.

•Adjust the Exhaust Restrictor to position C for a straight vertical colinear termination.

•Adjust the Exhaust Restrictor to position D for a vertical colinear termination with maximum 2 ft. offset.

Figure 12 . Colinear Termination / LP

11