Optional Blower # 156000
Connect the gas supply line to the stove, before installing the Blower.
Use a 90° Elbow off the control valve to create clearance required for the blower installation.
1.Unpack and check the contents of the blower kit. Contact your dealer if any damage is evident or parts are missing. See fig. 42.
2.Attach the Snapstat Bracket to the studs located in the middle of the firebox floor using the two M6 hex nuts and a 10 mm wrench. See fig. 43.
3.Attach the Blower Bracket to the stove using the two M6 flange head hex bolts as shown in fig. 43.
4.Attach the Duct Deflectors using the two #7 x 1/2” screws together with the finger guard mounting screws already in place. See #7 and #11 in fig. 42.
5.Install the Blower with the duct openings oriented up and forward. See fig. 44. Feed the wire harness through the bracket opening and secure the blower to the bracket with the wingscrew.
6.Attach either Snapstat wire connector to either Snapstat terminal. See fig. 44.
7.Install the Snapstat by sliding it all the way into the slot in the bottom of the Snapstat Bracket as shown in figs. 42 and 44.
8.Connect the male wire harness connector to the female wire harness connector already installed in the stove. See fig. 44.
9. Connect power cord to outlet.
THIS BLOWER MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE CURRENT ANSI/NFPA 70, NATIONAL ELECTRICAL CODE OR CSA
THIS UNIT IS SUPPLIED WITH A
ALWAYS DISCONECT THE POWER SUPPLY WHEN PERFORMING ANY SERVICE ON THE FIREPLACE INSERT.
6
7
| 5 |
|
| 8 |
|
|
|
| |
| 11 |
|
|
|
| 1 |
|
| 2 |
| 3 |
|
| |
|
| 9 |
| |
|
|
|
| |
|
| 4 |
|
|
|
|
| 7 | 10 |
Contents | Tools Required |
| ||
1. | Blower | • 10 mm wrench |
| |
2. | Mounting Bracket | * short phillips screwdriver | ||
3. | Snapstat Wire Harness | * | Safety Glasses |
|
4. | Control Switch Wire Harness |
| ||
* | Work Gloves |
| ||
5. | Snapstat |
| ||
|
|
| ||
6. | Snapstat Bracket |
|
|
|
7. | Blower Duct Deflector (2) |
|
|
|
8. | M6 Hex Head Flange Nuts (2) |
|
|
|
9. | M6 x 12 Hex Head Flange Bolts (2) |
|
|
10. M6 x 12 Wingscrew
11. #7 x 1/2” phillips screw (2)
Figure 42. Blower Kit Components
Hex Head
Flange Bolts
Snapstat
Bracket
Hex Head
Flange Nuts
Blower Bracket
Figure 43. Attach Snapstat and Blower Brackets.
25