Optional Antique Brick Panel Kit 155375
Tools Required: Safety glasses and gloves
1.Remove the Top Plate. Simply lift if up off of the stove body. It is not fastened.
2.Remove the Glass Frame. Disengage the two compression latches located at the top of the firebox and lift the glass frame up and off of the stove. See Fig. 1.
3.Remove the Logset.
These parts are not fastened. Simply lift them out of the firebox. You do not have to remove the embers.
4.Install the Rear Panel.
Tilt the Rear Panel top first to slide behind the exhaust baffle and position it up against the back wall.
5.Install the Side Panels. Tilt each panel, bottom edge first, into position against the side walls. The panels will stand on their own against the wall. Push them back against the Rear Panel.
6.Reinstall the Logset.
See page 21. BE CERTAIN THAT NO EMBERS ARE
BLOCKING THE PILOT ASSEMBLY OPENING.
7.Replace the Glass Frame.
Slide the frame down the slot in the front of the firebox. Be sure to push the frame into the slot in the bottom to ensure it is fully seated. The gasket at the top of the frame should be flush with the top of the firebox.
Pull the compression latches out to engage with the top lip of the glass frame.
8.Replace the Top Plate.
Left Panel | Right Panel |
220601 | 220600 |
Rear Panel 220599
Figure 47. Brick Kit Contents
Glass Frame
Latch
Figure 48. Release the glass frame latches.
Exhaust Baffle
Figure 49. Install the Rear Panel to fit behind baffle.
Figure 50. Install the Side Panels.
27