AV-61S902(E) 1/12/01 4:16 PM Page 61

Appendix B

2) Unplug the television.

Disconnect the television’s power cord from the AC outlet. Make sure the 10 LED lights have stopped blinking before you unplug the television. Never attempt to replace the lamp with the television plugged in.

3) Remove the left speaker panel.

The next step is to remove the left speaker panel located at the bottom of the front of the television cabinet. The top of the speaker panels are held with Velcro. Make sure the television is unplugged (see steps 1 and 2) before removing the speaker panel.

To remove the panel - Grab the panel from the side near the top. Gently pull the top away from the television. When the top part of the speaker panel is fully away from the television, lift up. The panel will come away from the bottom of the television. Set the panel aside.

4) Remove the filter cover.

The lamp is located behind the air filter unit. To access the lamp you will need to remove this filter unit and the fil- ter cover. To remove this filter cover you will need a Phillips head screwdriver. First loosen the screws located at the four corners of the panel. Once the screws have been loosened, slide the cover up until the large holes align with the screw heads. Gently pull the panel away from the television and set aside. (Please see Appendix A for

illustrations for removing the speaker panel and filter covers).

Interlock

 

5) Removing the filter unit.

switch

 

Next you will need to remove the filter unit. To remove the filter unit, use a

 

 

Coin etc.

 

something like a coin to loosen the three large-slotted screws fastening the

 

filter unit. When the screws have been loosened, slide the filter unit

 

 

 

 

out to remove it.

Filter unit

 

• Do not touch the surface of the filter or try to remove it from the filter unit.

 

These actions could damage the filter. If the filter is damaged, call a serv

 

Filter

 

ice technician to replace the filter.

 

 

WARNING: DO NOT attempt to remove the assembly until the lamp has fully cooled down. If you feel any heat near the lamp unit, STOP the removal and wait until the lamp has FULLY COOLED.

NEVER attempt to remove the lamp unit with the television plugged into a wall outlet.

DO NOT DROP the used lamp. The inside of the lamp is under pressure. Dropping or other hard shock could cause the lamp to shatter.

ALWAYS recycle the used lamp. Because the lamp contains a small amount of mercu- ry it cannot be thrown out with regular trash. Follow the recycling instructions includ- ed with the replacement lamp.

61

Page 61
Image 61
JVC AV-61S902 manual Remove the left speaker panel, Removing the filter unit