Video Signal Controls | JVC BM-H1900SU, BM-H1310SU guide

VIDEO SIGNAL CONTROLS

Push each switch to ON or OFF for video signal control.

UNDER SCAN

Push the UNDER SCAN switch to reduce the dimensions of display area so the whole picture is displayed on screen. Use to check the picture frame.

PULSE CROSS

Push the PULSE CROSS switch to simultaneously display two blank areas crossed horizontally and vertically on screen (“Pulse Cross” display) by delaying the phase of the input signal. Use to check the vertical retrace line period, equalizing pulse period, vertical sync period, horizontal sync pulse, or burst signal.

NOTE

● This function is not effective for analog RGB signal input.

COLOR OFF

Push the COLOR OFF switch to display a black-and-white picture by inputting a luminance signal only. Use to check the noise contained in a luminance signal or white balance.

BLUE CHECK

Push the BLUE CHECK switch to display a monochrome blue picture by eliminating red and green signal components. Use to check or adjust the CHROMA and/or PHASE controls.

NOTE

●This function is not effective for analog RGB signal input.

9

Image 9

JVC BM-H1900SU, BM-H1310SU manual Video Signal Controls, Push each switch to on or OFF for video signal control

Contents

BM-H1310SU Information Safety Precautions Features Contents Controls and Features Front Terminals and Features Rear RGB/COMPOSDI terminal setting Connection ExampleExternal/internal synchronization To demagnetize the picture tube Basic Operation Phase picture hue Picture AdjustmentsContrast picture contrast Bright picture brightness Push each switch to on or OFF for video signal control Video Signal Controls Aspect Ratio picture aspect ratio switching Calling up the menu display, selecting an itemFilter Select built-in filter selection Color TEMP. color temperature switching AFC switching of time constant for the AFCNtsc Setup Ntsc set-up level COMPO. Level chrominance level setting Revision of memory mode Variable setting range Memory Mode To call up SET-UP Menu and select a function SET-UP for Monitor Installation Input setting indications and selected inputs Remote Select TALLY/REMOTE-terminal settingsCNTL-1/CNTL-2 setting indications and set positions TALLY/REMOTE terminal functions Status Display setting the status display to on/off SET-UP for Monitor Installation Picture Setting Initialization To initialize Menu settings onlyTo initialize both MENU/SET-UP Menu settings Picture adjustments Remote ControlsSound adjustments On-screen menu remote operation To assign a monitor use remote control To program an ID number use front controlsTo call up an ID number use remote unit Before Calling for Service ¥ + Menu Menu Display Chart RGB / Compo SDI Specifications Dimensions BM-H1900SU / BM-H1310SU Color Video Monitor