Masterpage:Right0
EN 69
Filename [DX5SUS_12Editing.fm]
Page 69 Thursday, 1 September 2005 14:35

SYSTEM CONNECTIONS

These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using either an optional optical cable or an
optional coaxial cable.
NOTES:
For Dolby Digital sound, set ADIGITAL AUDIO OUTB to ADOLBY
DIGITAL/PCMB. (Apg. 70)
For DTS sound, set ADIGITAL AUDIO OUTB to ASTREAM/PCMB.
(Apg. 70)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards
to its Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to
the speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely
affect the playback picture.

Connecting To A Dolby Digital Decoder

Or An Amplifier With Built-in DTS

Dolby Digital Decoder or
amplifier with built-in DTS
Coaxial cable
(not supplied)
Rear of unit
Note for connection:
Remove the protection cap from the
optical cable.
To [DIGITAL AUDIO
OUT (COAXIAL)]
To DIGITAL AUDIO input
Optical cable
(not supplied)
To [DIGITAL AUDIO
OUT (OPTICAL)]
DX5SUS_00.book Page 69 Thursday, September 1, 2005 2:35 PM