JVC DR-MV5SE manual Automatic Satellite Programme, Recording DVD Deck Only, REC Mode

36 EN TIMER RECORDING

Automatic Satellite Programme	●	DECODER] connector.
		Make sure the satellite receiver is connected to the unit’s [L-2 IN/
Recording (DVD Deck Only)	● Programme the timer on the satellite receiver.
	● Slide the TV/DVD switch to DVD.
This function allows you to automatically record a satellite	1 Load a recordable disc.
programme which is timer-programmed on your external satellite	2 Press DVD so that the DVD lamp lights up on the unit.
receiver. Connect a satellite receiver to the unit’s [L-2 IN/	3 Press REC MODE repeatedly to set the recording mode.
DECODER] connector and programme the timer on the satellite
	4 Press and hold SAT # for about 2 seconds to engage the
receiver. The unit starts or stops recording by the signals input
from the satellite receiver. After recording, the unit’s power shuts	Automatic Satellite Programme Recording mode. “ ” appears on
off automatically.	the front display panel.
ATTENTION:	NOTES:
	● To disengage the Automatic Satellite Programme Recording mode,
● Be sure not to turn on the satellite receiver before the programme	press SAT #.
is executed; otherwise, the unit will start recording when the	● If the unit’s power is off, it is not possible to engage the Automatic
satellite receiver’s power is turned on.	Satellite Programme Recording mode.
● If you have connected another appliance other than a satellite	● In step 4, if “ ” blinks quickly on the front display panel even though
receiver to the [L-2 IN/DECODER] connector, be sure not to	your satellite receiver’s power is off, Automatic Satellite Programme
engage the Automatic Satellite Programme Recording mode;	Recording will not work properly with that satellite receiver*. If this is
otherwise, the unit will start recording when the connected	the case, perform “Manual Timer Programming” ( pg. 31) to
appliance’s power is turned on.	timer-record a satellite programme.
● Automatic Satellite Programme Recording and timer-recording	* Some satellite receivers output signals even if the power is off.
cannot be done at the same time.		Automatic Satellite programme Recording is not possible with those
		satellite receivers.
	● “	” blinks on the front display panel while Automatic Satellite
	Programme Recording is in progress.
	● For timer programming of the satellite receiver, refer to the instruction
	manual of the satellite receiver.
	● Automatic Satellite Programme Recording is not possible if your
DVD	satellite receiver does not have a timer.
	● Pressing the unit’s 1 button while Automatic Satellite Programme
	Recording is in progress turns off the unit’s power and disengages
	the Automatic Satellite Programme Recording mode.
	● If there are more than one satellite programmes you wish to record
	with Automatic Satellite Programme Recording, it is not possible to
	set different recording modes for each programme.
	● Depending on the type of satellite receiver, the unit may not record a
	slight portion of the beginning of the programme or may record
SAT	slightly longer than the actual length of the programme.
	● If you engage the Automatic Satellite Programme Recording mode

when the satellite receiver’s power is on, the unit will not start Automatic Satellite Programme Recording even though “ ” blinks on the front display panel. When the satellite receiver shuts off once and is turned back on again, the unit starts recording.

● Just Clock ( pg. 88) does not work when the Automatic Satellite Programme Recording mode is engaged.

● You can also record a programme from your cable system in the same way if the system has a timer.

REC MODE