Masterpage:Right+
EN 77
Filename [MV5S_12RemoSys.fm]

SYSTEM CONNECTIONS

Page 77 Wednesday, 8 June 2005 11:05
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using an optional coaxial cable.
NOTES:
For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (pg.78)
For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
(pg.78)
CAUTIONS:
This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
When you can’t switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional coaxial cable and “DIGITAL AUDIO OUT” is set to
“DOLBY DIGITAL/PCM”, it is not possible to switch the audio
channel of a bilingual programme recorded on a DVD-RAM or
DVD-RW (VR mode) disc. In this case, perform the following steps
using the remote control to switch “DIGITAL AUDIO OUT” from
“DOLBY DIGITAL/PCM” to “PCM ONLY”.
APress SET UP to access the Main Menu screen.
BPress we to select “DVD SET UP”, then press t.
CPress we to select “AUDIO OUTPUT”, then press t.
DPress rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
EPress rt to select “PCM ONLY”, then press ENTER.
(pg.78)
FPress SET UP to complete the setting.
GPress AUDIO to select the desired audio channel. (pg. 50)
The [L-2 IN/DECODER] connector can be used as an input
connector for an external decoder (descrambler). Simply connect a
decoder and you can enjoy a variety of programming that is
available through scrambled channels.
1Set “L-2 SELECT” to “DECODER”. (pg.45)
2Connect your unit’s [L-2 IN/DECODER] connector to the
decoder’s 21-pin SCART connector using a 21-pin SCART cable.
3Perform the procedure as described in “When Receiving A
Scrambled Broadcast (DVD Deck Only)” (pg.87). (DVD deck
only)
Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not provided)
Rear of unit
To [DIGITAL AUDIO
OUT (COAXIAL)]
Connecting/Using A Decoder (DVD Deck Only)
TV
RF cable (provided)
TV aerial cable
L-1 IN/OUT
L-2 IN/
DECODER
Decoder
MV5S_12RemoSys.fm Page 77 Wednesday, June 8, 2005 11:05 AM