JVC DR-MX1S CH +/–, REC MODE, VHS/HDD/DVD SELECT, If the camcorder has no S-VIDEOoutput connector:

EDITING EN 75

	Edit From A Camcorder	● Slide the TV/CABLE/DBS/DVD switch to DVD.
		1 Make connections.
You can use a camcorder as the source player and your unit as the
		A If the camcorder has no S-VIDEO output connector:
recording deck.
		— connect the camcorder’s AUDIO/VIDEO OUT connectors to the
A	If the camcorder has no S-VIDEO output connector:	unit’s [VIDEO/AUDIO ((MONO) L/R)] input connectors on the front
		panel.

		● When using a monaural camcorder, connect its AUDIO OUT
		connector to the [AUDIO-L] input connector on your unit.
		B If the camcorder has an S-VIDEO output connector:
		— connect the camcorder’s AUDIO OUT and S-VIDEO OUT
		connectors to the unit’s [AUDIO] and [S-VIDEO] input connectors
		on the front panel.
To [VIDEO/AUDIO	Recorder	2 Press VHS/HDD/DVD SELECT on the unit repeatedly to select
((MONO) L/R)] input		the recording deck.
		3 Press CH +/– to select “F-1”.
Audio/video cable		● Set “FRONT AUX F-1” to “VIDEO” for the VIDEO input connector, or
		“S-VIDEO” for the S-VIDEO input connector, depending on the
(not supplied)
		connector being used. ( pg. 83)
		4 Press REC MODE repeatedly to set the recording mode.
		5 Start playback on the camcorder slightly before the actual point
		from where you wish to start dubbing.
		6 Press 7 on the unit to start recording. Or while holding 7, press
		4 on the remote control. The dubbing starts.
		7 Press 8 on the unit, then stop playback on the camcorder.
		NOTES:
AUDIO/VIDEO OUT		● All necessary cables can be obtained from your dealer.
		● Refer to the camcorder’s instruction manual for operating procedure.
Player		● The quality of dubbed picture becomes poorer than that of the
		original.

BIf the camcorder has an S-VIDEO output connector (HDD & DVD deck only):

To	To [AUDIO] input	Recorder
[S-VIDEO]
input

S-video cable

(not supplied)

Audio cable (not supplied)

S-VIDEO OUT

AUDIO OUT

Player