Index of Parts and Functions (cont.)

ySCOPE button/lamp

Displays/hides the indication of the wave form monitor and vectorscope (☞ “Scope Setting” on page 36). ● Each time you press this button, the window changes in the following order.

No display

Wave form monitor

HistogramVectorscope

uFor DT-V9L5: DC lamp / For DT-F9L5: BATT. lamp

When the DC power voltage is being lowered due to the battery consumption, the lamp changes to orange from green. When the voltage becomes lower than a certain level, the monitor automatically turns off and the lamp turns to red.

●For DT-V9L5: Make sure to turn off the POWER switch (☞ 1 on page 28) and DC switch (3 on page 29) on the rear panel before replacing

the battery. / For DT-F9L5: Make sure to turn off the POWER switch (☞ 3 on page 29) on the rear panel before replacing the battery.

●The length of time that the lamp lights in orange differs depending on the type of battery or the battery condition. It is recommended to replace the battery when the lamp turns to orange.

Rear panel

DT-V9L5

Carry handle

Security slot

 

Use this handle when carrying the monitor.

Attach a security wire to this slot.

Common
DT-F9L5

Back tally lamp

This lamp is controlled by the tally function of the MAKE/TRIGGER terminal.

• The setting of the lamp is linked to the red tally lamp on the front panel.

(☞ “Tally Setting” on page 37 and “External Control” on page 42)

Carry handle

Use this handle when carrying the monitor.

Battery mount

(☞ page 26)

1POWER switch (DT-V9L5 only)

Turns AC power on or off.

● You need to press button (☞ q on page 27) to use the monitor after turning on the POWER switch.

28