Menu Configuration (cont.)
Picture Sub Adjust
Configure the standard level of image adjustment.
Item | To do | Setting value | |
Contrast*1 | Adjust the standard level for the contrast adjusted with the CONTRAST knob on the front | ||
|
| panel. |
|
Bright*1 | Adjust the standard level for the brightness adjusted with the BRIGHT knob on the front | ||
|
| panel. |
|
Chroma*1 | Adjust the standard level for the chroma adjusted with the CHROMA knob on the front panel. | ||
Phase*1,*2 | Adjust the standard level for the phase adjusted with the PHASE knob on the front panel. | ||
NTSC Setup | Select the | 00 (compliant with 0 % | |
|
|
| |
|
|
| with 7.5 % |
Component Level | Select the level of the analog component signal (480i and 576i only). | B75 (compliant with | |
|
|
| BetacamVTR 7.5 % |
|
|
| signal), B00 (compliant with |
|
|
| BetacamVTR 0 % |
|
|
| signal), SMPTE (compliant |
|
|
| with M2VTR signals) |
sub menu | Display the sub menu which enables you to adjust the items in “Picture Sub Adjust” while viewing the actual picture. | ||
reset | Restore the default settings for all the items in “Picture Sub Adjust”. |
| |
*1 | Memorized for each input. |
| |
*2 | When “Component Phase” (☞ page 37) is set to “Disable,” “Phase” cannot be adjusted if no NTSC signal is input. |
|
White Balance Setting
Display the color temperature, and adjusts the drive level and cutoff point of each color (R/G/B).
Item | To do | Setting value |
Color Temperature | Select the color temperature. (Cannot be set/changed) | 9300K, 6500K, User |
R Drive *1 | Adjust the drive level of each color (red, green, and blue). | Min – 000 – Max |
G Drive | ● The maximum (Max) and minimum (Min) values vary depending on the input signal or | (in 1024 grades) |
B Drive | other settings. |
|
R Cut Off *1 | Adjust the cutoff point of each color (red, green, and blue). | Min – 000 – Max |
G Cut Off | ● The maximum (Max) and minimum (Min) values vary depending on the input signal or | (in 1024 grades) |
B Cut Off | other settings. |
|
sub menu | Display the sub menu which enables you to adjust the items in “White Balance Setting” while viewing the actual picture. | |
reset | Restore the default settings for all the items in “White Balance Setting”. |
|
*1 Memorized for each color temperature.
Remote Setting
Settings for the external control.
Item | To do | Setting value |
Parallel Type | Select a control method of the MAKE/TRIGGER terminal. | Make, Trigger, Set |
Pin1 |
|
|
Pin2 | Assign the control functions to the pins of the MAKE/TRIGGER terminal. | ☞ "Display" in "Functions |
Pin3 | • Assign a function to each pin terminal by selecting “Set” in “Parallel Type” mentioned | controlled by the MAKE/ |
Pin4 | above. | TRIGGER system" on page 43 |
Pin5 |
|
|
Pin6 | The functions are assigned for “Pin6” – “Pin8” and you cannot change the assignment of | Tally |
Pin7 | these functions. | Enable |
Pin8 |
| GND |
38