Menu Configuration (cont.)

Scope Setting*1

Configure the settings for the wave form monitor and vector scope.

Item

To do

 

 

 

Setting value

Gain*2

Adjust the input gain level.

 

–10 to +10

Size*3

Set the window size.

 

Normal, Large

Position

Select the window position.

 

Lower Right, Lower Left

 

 

 

 

 

Upper Left, Upper Right

Transparent

Activates/deactivates the function to make the window translucent.

 

Off

 

Off

:

Normal

 

On

 

 

 

 

On

:

Translucent

 

 

Auto Off

Set the function to turn off the window automatically 15 minutes after displayed.

 

Off, On

Histogram Display

Select the signal component for the histogram display.

 

Y, R, G, B, RGB*4

Wave Display

Select a wave form to be displayed for the wave form monitor.

 

Y, Pb, Pr (HD signal)

 

 

 

 

 

Y, Cb, Cr (SD signal)

 

 

 

 

 

R, G, B (RGB signal)

Wave Filter

Turn on/off the lowpass filter to put over the input wave form data.

 

Flat (No filter)

 

 

 

 

 

Lowpass

 

 

 

Wave Over Level Marking

Turn on/off the function to change the wave form color of signals over the value specified in

Off, On

 

“Wave Over Level”. (☞ below)

 

 

Wave Over Level

Adjust the lower limit for the over level.

 

70 – 109

<Example of the histogram

display>

 

<Example of the wave form monitor>

<Example of the vector scope>

Pixels

< dark

brightness

light >

The start and the end of the gradient correspond to 0% and 100% of the signal. (DT-F9L5 only)

RedWhite

Y

Image signals

Start

End

Ex.: When the luminance signal is Y, “Wave Over Level Marking” is set to “On” and “Wave Over Level” is set to “80”

Ex.: When the color bar is displayed

 

• The wave form color of signals over the value

 

specified in “Wave Over Level” turns red.

 

• The display differs depending on the input

 

signal or the “Wave Display” setting.

*1

The vector scope is not displayed when the input signals are RGB.

*2

Unavailable for the histogram.

*3

Only “Normal” is available for the histogram. (DT-V9L5 only)

*4

DT-F9L5 only.

Sync Function

Settings for the synchronization with signals.

Item

To do

Setting value

No Sync Action

Select the screen status when no signal is coming in.

Off, Standby, Power Save

 

 

(power save mode),

 

 

Gray Back (gray screen)

Delay Time

Select the period until the screen status changes as selected in “No Sync Action” after signals

30s, 5min, 15min

 

stop coming in.

 

Low Latency

Activates/deactivates the function to shorten the time taken to display the picture (low

Off, On

 

latency function).

 

 

• If the picture is not displayed steadily while “On” is selected, select “Off.”

 

 

• While “On” is selected, the displayed picture may become unstable when an operation

 

 

using buttons on the front panel or the menu is performed, or when the signal format

 

 

changes.

 

●When setting “No Sync Action” to “Gray Back,” the screen color changes to gray and the power consumption of the backlight is saved by half. Selecting “Power Save” (power save mode) saves more power consumption by turning off the backlight.

36