
TROUBLESHOOTING | EN 69 |
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a
1 | SYMPTOM | POSSIBLE CAUSES |
2No power is supplied. | • The power is not connected | |
|
| properly. |
|
| • The battery is dead. |
3“SET DATE/TIME!” appears. • The date/time is not set.
•The
Recording cannot be | — For Tape Recording — |
performed. | • The tape’s erase protection tab is |
| set to “SAVE”. |
| • The Power Switch is set to “PLAY” |
| or “OFF”. |
| • The VIDEO/MEMORY Switch is set |
| to “MEMORY”. |
| • “TAPE END” appears. |
| • The cassette holder cover is open. |
| — For Memory Card Recording — |
| • The VIDEO/MEMORY Switch is set |
| to “VIDEO”. |
CORRECTIVE ACTION
•Connect the AC Adapter securely ( pg. 9).
•Replace the dead battery with a fully charged one ( pg. 8, 9).
•Set the date/time ( pg. 11).
•Consult your nearest JVC dealer for replacement.
•Set the tape’s erase protection tab to “REC” ( pg. 12).
•Set the Power Switch to “ AUTO ” or “ MANUAL ” ( pg. 17).
•Set the VIDEO/MEMORY Switch to “VIDEO”.
•Replace with new cassette ( pg. 12).
•Close the cassette holder cover.
•Set the VIDEO/MEMORY Switch to “MEMORY”.
54There is no picture. | • The camcorder is not getting power, | • Turn the camcorder’s power off and |
| or some other malfunction exists. | on again ( pg. 17). |
|
|
|
The focus does not adjust | • Focus is set to the Manual mode. | • Set Focus to the Auto mode |
automatically. | • The recording was done in a dark | ( pg. 43). |
| place, or the contrast was low. | • Clean the lens and check the focus |
| • The lens is dirty or covered with | again ( pg. 74). |
| condensation. |
|
|
|
|
|
| CONTINUED ON NEXT PAGE |