64
EN
USING THE REMOTE CONTROL UNIT
(cont.)
Insert Editing
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in and
outpoints. The original audio remains unchanged.
NOTES:
●Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen
(墌 pg. 49, 51).
●Insert Editing is not possible on a tape recorded in the
LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the
television, make connections (墌 pg. 22).
1Play back the tape, locate the Edit-Out point and
press PAUSE (6). Confirm the time code at this point
(墌 pg. 49, 51).
2Press REW (
2) until the Edit-In point is located,
then press PAUSE (6).
3Press and hold INSERT (w) on the remote
control, then press PAUSE (6). “6w” and the Time
Code (min.:sec.) appear and the camcorder enters
Insert-Pause mode.
4Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in
step 1.
•To pause editing, press START/STOP. Press it again
to resume editing.
5To end Insert Editing, press START/STOP, then
STOP (5).
NOTES:
●Programme AE with special effects (墌 pg. 38, 39) can
be used to spice up the scenes being edited during
Insert Editing.
●During Insert Editing, the date and time information
changes.
●If you perform Insert Editing onto a blank space on the
tape, the audio and video may be disrupted. Make sure
you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert
Edting stops (墌 pg. 86).
w
6
12:34
PLAY
PAUSE
INSERT
REW
START/STOP
STOP
Power Switch
Display
Remote sensor
Lock Button