JVC GR-DVX9 specifications EN63, To DV IN/OUT Core filter DV cable optional To DV OUT

Make sure all units are turned off. Connect the camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.

POWER Switch

Lock Button

Open the connector cover.

To DV IN/OUT

Core filter

DV cable (optional)

Core filter

To DV OUT

Video unit equipped with DV connector

EN63

Dubbing From A Video Unit Equipped With A DV Connector (Digital Dubbing)

[To use this camcorder as a recorder: Only for GR-DVX10 owners]

NOTE:

Before the following steps, make sure that “AV/S-VIDEO” is set to “OUT” in the Menu Screen (
pg. 41).

1

2 Set “REC MODE” to “SP” or “LP” in the Menu Screen depending on your preference (
pg. 11).

3 Set this camcorder’s POWER Switch to “” while pressing down the Lock Button located on the switch. Turn on the video unit’s power and insert the appropriate cassettes in the camcorder and the video unit.

4 Press START/STOP on the camcorder to engage the Record-Pause mode.

“DV. IN” appears on the screen.

5 Engage the video unit’s Play mode, then engage the Still Playback mode when you have found a spot just before the edit-in point.

6 Press START/STOP on the camcorder to engage the

Record mode. “ DV. IN ” appears on the screen. Engage the video unit’s Play mode.

7 To stop dubbing, press START/STOP on the camcorder so that “DV. IN” reappears, then engage the video unit’s Stop mode.

8 Repeat steps 5 through 7 for additional editing.

NOTES:

●It is recommended to use the AC Power Adapter/ Charger as the power supply instead of the battery pack (
pg. 7).

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●For Digital Dubbing, this camcorder can be connected only to one device at a time.

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this occurs, turn off the power and make connections again.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting (
pg. 27).

●During Digital Dubbing, no signals are output from the video or audio connectors.