84EN | TROUBLESHOOTING (cont.) |
SYMPTOM
45.The LCD monitor, the viewfinder and the lens have become dirty
(ex. fingerprints).
46.An unusual mark appears.
47.An error indication (E01 — E06) appears.
48.The charger indicator on the AC Power Adapter/Charger does not light.
49.Picture does not appear on the LCD monitor.
50.When the image is printed from the printer, a black bar appears at the bottom of the screen.
51.When the camcorder is connected via the DV connector, the camcorder does not operate.
52.During transport, the lens cover opens.
53.The MultiMediaCard cannot be removed from the camcorder.
POSSIBLE CAUSES |
| CORRECTIVE ACTION |
45. |
| 45. • Wipe them gently with soft |
| cloth. Wiping strongly can | |
| cause damage ( pg. 78). | |
|
| |
|
|
|
46. |
| 46. • Check the section of the |
| manual that explains LCD | |
| monitor/viewfinder indica- | |
|
| |
|
| tions ( pg. 88 – 92). |
|
|
|
47. • A malfunction of some kind |
| 47. • Remove the power supply |
has occurred. In this case the |
| (battery pack, etc.) and wait a |
camcorder’s functions |
| few minutes for the indication |
become unusable. |
| to clear. When it does, you |
|
| can resume using the |
|
| camcorder. |
|
| If the indication remains even |
|
| though you repeat the above |
|
| two or three times, please |
|
| consult your nearest JVC |
|
| dealer. |
|
|
|
48. • The temperature of the battery |
| 48. • To protect the battery, it is |
is extremely high/low. |
| recommended to charge it in |
• Charging is difficult in places |
| places with a temperature of |
subject to extremely high/low |
| 10° C to 35° C ( pg. 93). |
temperatures. |
|
|
|
|
|
49. • The viewfinder is pulled out. |
| 49. • Push the viewfinder back in. |
• The LCD monitor's brightness |
| • Adjust the brightness of the |
setting is too dark. |
| LCD monitor ( pg. 16). |
|
| • If the monitor is tilted upward |
|
| 180 degrees, open the |
|
| monitor fully ( pg. 16). |
|
|
|
50. • This is not a malfunction. |
| 50. • By recording with “DIS” |
|
| activated ( pg. 28) this can |
|
| be avoided. |
|
|
|
51. • The DV cable was plugged/ |
| 51. • Turn the camcorder’s power |
unplugged with power turned |
| off and on again, then operate |
on. |
| it. |
|
|
|
52. |
| 52. • Do not subject the camcorder |
| to shock or excessive | |
| vibration during transport. | |
|
| • Turn the camcorder on and |
|
| off. The lens cover closes. |
|
|
|
53. |
| 53. • Push in the MultiMediaCard a |
| few more times ( pg. 12). | |
|
|
|
