JVC GY-DV500 Using External Components, Writing S.S.F. Data to Tape, Outputting S.S.F. Data

10. S.S.F. (Super Scene Finder) FUNCTION

10-5 Writing S.S.F. Data to Tape

11. USING EXTERNAL COMPONENTS

11-1 Connecting a Video Component with DV Connector

LOG REW STOP FF PLAY STILL

1. STOP button

2. LOG button 2. REW button

S.S.F. data stored in the unitís memory can be written to the beginning of tape.

Operation

1. Press the STOP button to enter the stop mode.

2. Press the REW button while the LOG button is kept pressed.

•	The REW indicator blinks during tape transport in the
	writing position.
•	The LOG indicator lights while S.S.F. data are being
	written to the tape.

Rear section of GY-DV500

Video component with DV Connector

FILTER

ALARM

MONITOR

AUDIO

LEVEL

	GAIN	OUTPUT	WHT.BAL
VTR
	NG	POWER

• When writing to the tape is completed, the LOG indicator

goes out.

About the Scene End Cue Up Function

DV CH-1 AUDIO IN CH-2 TALLY

DC INPUT

DV connector

DV connector

CH-1	AUDIO	CH-2	CH-2		TC GENERATOR
	LEVEL	CH-1
			AUTO	PRESET	FREE
			MANUAL	REGEN	REC
		AUDIO SELECT
		AUDIO INPUT
		CH-1	CH-2	CONTINUE		MENU
			FRONT
			REAR
	LITHIUM BATT.		GROUP	ITEM	SELECT	DATA SET
			HOLD	SHIFT	ADVANCE	PRESET

CONTINUE button

When the CONTINUE button is pressed while the LOG button is kept pressed in the stop mode, the tape winds to the S.S.F. data’s last OUT point, after which the unit enters the record-pause mode. (Scene End Cue Up)

The FF button’s LED blinks during the Scene End Cue Up mode.

Note:

Once a tape with recorded S.S.F. data is ejected and then reinserted again, the previous data will be erased if new S.S.F. data are recorded on the tape.

DV cable

Connection

Connect the DV connector on the GY-DV500 to the DV connector on the video component using the DV cable.

Settings

Recording the image of the video component with DV connector on the GY-DV500

Recording the playback image or audio of the GY-DV500 on the video component with DV connector

10-6 Outputting S.S.F. Data

PUSH

DV CAMCORDER

GY-DV500

Y/C OUT MONITOR OUT	LINE OUT
	CH-1 CH-2

VTR

REMOTE

The S.S.F. data stored in the unit's memory can be output by RS-232C control via the VTR REMOTE connector.

SYNC IN TEST OUT

MIC IN

LENS

•To input the image via the DV connector, set the VCR Setup Menu item No. 126 INPUT SELECT to "IEEE1394".

*Settings cannot be changed during recording.

☞See page 68.

↑

U-ver. only

•To remote control the playback operation of the GY-DV500 from the video component with DV connector, set the VCR Setup Menu item No. 050 REMOTE SELECT to "IEEE1394".

☞ See page 68.

VTR REMOTE connector

6364