Audio Dubbing
EN57
Audio dubbing replaces the normal audio sound of a previously recorded tape with a new soundtrack. Use your VCR as the recorder.
STOP | PLAY |
PAUSE
Normal audio track
Pre-recorded tape
Audio-dubbed tape
Audio cable
Audio component (CD player etc.)
NOTES:
● When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the
● Audio dubbing stops automatically when the counter reaches "0:00:00", and the VCR enters the Play mode. Check the counter reading before dubbing.
● Audio dubbing is also possible using the rear AUDIO IN connectors. When using these connectors, be sure to select "REAR
● Audio dubbing cannot be performed on a cassette that has had its record safety tab removed.
● When playing back an
● Picture may be distorted during Audio Dubbing Pause. ● It may be unlawful to record or play back copyrighted material without the consent of the copyright owner.
MAKE CONNECTIONS
1 Connect an audio component to the AUDIO IN L + R connectors on the VCR's front panel. *When connect- ing monaural equipment, use only the VCR's AUDIO IN L connector.
SET INPUT MODE
2 Press the remote control's NUMBER key "0" and CH so that
●Be sure to select "FRONT
| LOCATE START POINT |
| Press PLAY to start playback of the tape in your VCR, |
| and press PAUSE when you find the point where you |
3 want to start dubbing. | |
4 | ENGAGE AUDIO DUBBING |
Press A. DUB. | |
| |
● Your VCR enters the Audio Dubbing Pause mode. | |
( blinks, and light up on the front display | |
| panel.) |
|
|
| START DUBBING |
| Engage the audio component's Play mode, then press |
| PLAY to start the tape in your VCR. Audio dubbing |
5 begins at this point. |
● blinks and is displayed on the front display panel.
●To stop dubbing temporarily, press PAUSE. Press PLAY to resume dubbing.
END AUDIO DUBBING
6 Press STOP to stop the tape in your VCR, and engage the audio component's Stop mode.