62
EN
SPECIAL
FEATURES
(cont.)
DBS Receiver Multi-Brand
Remote Control
POWER
VCR/TV/CABLE/DBS
ENTER
| 1 | 2 | 3 |
|
|
| 2 |
NUMBER | 4 | 5 | 6 |
|
|
| |
| 7 | 8 | 9 |
|
| 0 | 4 |
1
STOP
TV CH +
TV CH – 
DBS BRAND NAME | BRAND CODE |
|
|
JVC (DISH Network) | 51 |
ECHOSTAR (DISH Network) | 51 |
PRIMESTAR | 50 |
SONY (DSS) | 41 |
RCA (DSS) | 40 |
|
|
(Ex.) To set remote control to JVC 51:
POWER
5 | 1 | STOP | Release |
|
The VCR's remote control can control functions on the brands of DBS (Direct Broadcast Satellite) receivers listed below.
|
|
| TURN ON THE DBS |
| 1 |
| RECEIVER |
|
| Turn the power on using the DBS receiver’s remote | |
|
| control. | |
|
|
| SET REMOTE CONTROL |
| 2 |
| MODE |
|
| Set the VCR/TV/CABLE/DBS switch on the VCR’s | |
|
| remote control to CABLE/DBS. | |
| 3 |
| ENTER DBS RECEIVER BRAND |
|
| While holding down POWER on the VCR's remote | |
|
| control, use the NUMBER keys to enter the DBS receiver | |
|
| brand number from the chart below and then press STOP. | |
|
|
| Follow the example shown at bottom left. |
|
|
|
|
|
|
| ● Once you have set the remote control to operate the |
|
|
| DBS receiver, you don't have to repeat this step until |
|
|
| you replace the remote control's batteries. |
|
|
|
|
| 4 |
| OPERATE DBS RECEIVER |
|
| First, press POWER to see if the DBS receiver’s power | |
|
| goes off as it should. If it does, try other functions (TV | |
|
| CH +/– and the NUMBER keys can be used to operate | |
|
|
| the DBS receiver). |
|
|
|
|
|
|
| ● For some brands of DBS receiver, you must press |
|
|
| ENTER after having pressed the NUMBER keys. |
|
| ● To return the remote to VCR control, set the VCR/TV/ | |
|
|
| CABLE/DBS switch to VCR. |
|
|
|
|
NOTES:
●You must set the DBS receiver brand for your remote control and the DBS receiver brand for your Controller (☞ pg. 21) separately.
●Depending on the type of DBS receiver, there may be cases where some or all functions cannot be operated using the remote control.
●It's not possible to operate a DBS receiver that is not equipped with a remote control sensor.
●Though ECHOSTAR has a number of different remote codes, this remote control is applicable only to one of those codes preset at the factory.
●It's not possible to set the remote control for both your DBS receiver and a cable box at the same time. You can only set the remote control to operate one of these units at a time.
Hold down | Press in succession |
