Masterpage:Right0

EN 13

Filename [XVC24S_06Index.fm]
Page 13 28 February 2005 9:11 am

INSTALLING YOUR NEW UNIT

Basic Connections
Its essential that your unit be properly connected.
ACheck the contents.
Make sure the package contains all of the accessorie s
listed in SPECIFICATIONS on page71.
BSituate the unit.
Place the unit on a stable, horizontal surface.
CConnect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO AV input connectors —
ADisconnect the TV antenna from the TV.
BConnect the TV antenna cable to the VHF/UHF IN
connector on the rear panel of the unit.
CConnect the supplied RF cable between the VHF/UH F
OUT connector on the rear panel of the unit and the
TVs antenna terminal.
AV Connection
8To connect to a TV with AV input connectors —
AConnect the antenna, unit and TV as per RF
Connection.
BConnect an optional audio/video cable between the
AUDIO/VIDEO OUTPUT connectors on the rear
panel of the unit and the TVs audio/video input
connectors.
Set your TV to AV mode.
For switching the TVs mode, refer to the instruction manual of
your television.
To obtain high-quality pictures, you can also use the
Component Video Connection. (DVD deck only) (pg.14)
DConnect the unit to power source.
Plug the end of the AC power cord into an AC outlet. This
unit performs Plug & Play Set automatically. (pg.16)
The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet. (If AUTO and the channel
indicator are displayed on the front display panel before the
unit is powered on, the clock and tuner channels are being set
automatically. Wait for the time to be di splayed on the front
display panel before turning on the unit.)
ESet the VCR channel.
The VCR channel is the channel on which you can watch
the picture from the unit on the TV when only using RF
connection.
With RF connection, set the VCR channel to 3 CH or
4CH.
The VCR channel is preset to 3 CH. Set to 4CH if the
Channel 3 is used for broadcasting in your area.
With AV connection, set the VCR channel to “– CH (off).
To set the VCR channel, perform the following steps:
APress POWER to turn off the unit, then press 8 STOP
on the unit for more than 5 seconds. 3 CH appears
on the front display panel.
BPress CH +/– on the Remote to select 3 CH, 4CH
or “– CH (off), then press ENTER.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
Antenna or Cable
Matching transformer
(not supplied)
Coaxial cable
VHF/UHF OUT
VIDEO OUTPUT
AC Outlet
RF cable
(supplied)
Back of unit VHF/UHF
IN
AUDIO
OUTPUT
Audio/video cable
(not supplied)
Flat feeder
TV
AC Power Cord
To 75 ohm
Terminal
To Audio/video
input connectors
Before performing the following steps:
Make sure there is no cassette inserted in the unit.
Make sure the unit is turned on, then press VCR/
DVD on the unit or VCR on the Remote so that the
VHS indicator lights up on the front display panel.
XVC24S_01.book Page 13 Monday, February 28, 2005 9:24 AM