![](/images/new-backgrounds/1312960/31296027x1.webp)
14 EN | INSTALLING YOUR NEW UNIT (cont.) |
Component Video Connection
(DVD deck only)
ATTENTION
Be sure to connect the unit’s VIDEO OUTPUT (DVD/ VCR) connector to the TV’s VIDEO input connector.
Antenna or Cable
Coaxial cable
Flat feeder
Matching transformer (not supplied)
8To connect to a TV with component video input connectors . . .
A Connect the unit to TV.
AConnect the antenna, unit and TV as per “AV
Connection.” ( pg. 13)
BConnect the unit’s COMPONENT VIDEO OUT connectors to the TV’s component video input connectors.
B Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet. This unit performs Plug & Play Set automatically. ( pg. 16)
●The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is first connected to an AC outlet. (If “AUTO” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)
C Set the VCR channel to off.
Before performing the following steps:
AC outlet
AUDIO OUTPUT
● Make sure there is no cassette inserted in the unit. |
● Make sure the unit is turned on, then press VCR/ |
DVD on the unit or VCR on the Remote so that the |
VHS indicator lights up on the front display panel. |
VIDEO OUTPUT
AC power cord COMPONENT VIDEO
OUT
Back of unit
|
| VHF/UHF |
|
| IN |
Component | Audio/Video | VHF/UHF |
Video cable | cable | OUT |
(not supplied) | (not supplied) |
|
|
| RF cable |
|
| (supplied) |
To Component Video | To 75 ohm |
Input connector | Terminal |
| TV |
APress POWER to turn off the unit, then press 8 STOP on the unit for more than 5 seconds. “3 CH” appears on the front display panel.
BPress CH +/– on the Remote to select “– CH” (off), then press ENTER.
NOTES:
●You can obtain
●If your TV is not
●To operate the unit with your TV using the Component Video connection, set your TV to its AV mode. You can also use the TV/VCR button on the unit’s Remote to set JVC TV to the AV mode.
For switching the TV’s mode, refer to the instruction manual of your television.
●By using the component video connection, you can view the images in the progressive mode. For switching to the
progressive mode, refer to “Scan Mode Set (DVD deck only)” ( pg. 15).