Masterpage:Right-No-Heading

EN 57

Filename [XVC24S_09Editing.fm]
Page 57 28 February 2005 9:11 am
Connecting To A Dolby Digital Decoder or An Amplifier With A Built-in DTS(DVD deck only)
These instructions enable you to connect your unit to dolby digital decoder or amplifier with a built-in DTS.

Make connections.

Connect the coaxial cable between the unit and the
Dolby Digital decoder or amplifier with a built-in DTS.
NOTES:
For Dolby digital sound, set DIGITAL AUDIO OUTPUT to
DOLBY DIGITAL/PCM. (pg.62)
For DTS sound, set DIGITAL AUDIO OUTPUT to STREAM/
PCM. (pg.62)

CAUTIONS:

This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
Back of unit
Coaxial cable
(not supplied)
Dolby Digital decoder or
amplifier with a built-in DTS
DIGITAL AUDIO OUT
To DIGITAL AUDIO
input
XVC24S_01.book Page 57 Monday, February 28, 2005 9:24 AM