JVC HR-XVC24S manual Tape Remaining Time, Second Audio Recording, Set the counter display

EN 33

Slide to the right.

C.RESET

ON SCREEN

DISPLAY

Elapsed Recording Time Indication

1Set the counter display.

Press DISPLAY until a counter reading appears on the front display panel.

2Reset the counter.

Press C.RESET before starting recording or playback.

●The counter is reset to “0:00:00” and shows the exact elapsed time as the tape runs. You can check the exact time of a recording or playback.

Tape Remaining Time

Press DISPLAY until the time remaining on the tape appears.

●The front display panel shows the tape remaining time with “:” blinking.

●By pressing the DISPLAY button, you can change display to show the channel position*, clock time, counter reading or tape remaining time.

*Channel position is not displayed during playback.

NOTES:

●When you press ON SCREEN, the on-screen display appears on the TV screen for 5 seconds, then the displays other than the counter disappears. To clear the counter display, press ON SCREEN.

●Depending on the type of tape being used, the tape remaining time reading may not appear right away, or is not correct.

“– –:– –” may sometimes appear with “:” blinking, or the display may blink on occasion.

Second Audio Recording

This unit’s built-in MTS decoder enables reception of Multichannel TV Sound broadcast. To record a SAP program received, set “2ND AUDIO RECORD” to “ON.” ( pg. 60)

NOTE:

When the channel is changed on the unit;

●The “STEREO” indicator appears on the screen for about 5 seconds if the program is a stereo broadcast.

●The “SAP” indicator appears on the screen for about 5 seconds if the program is a SAP broadcast.

●Both indicators appear when a stereo program is accompanied by SAP sound.