Additional preparation

Connecting methods

1Connect the TV’s VIDEO jack and the device’s VIDEO OUT (video output) jack with a video cable.

If connecting a device to the TV with an S-VIDEO cable:

Connect the VCR’s S-VIDEO OUT (S- VIDEO output) connector and the TV’s S connector with an S-VIDEO cable, instead of connecting with a video cable.

Note that the connection with a video cable will be ignored in case you connect a VCR to the TV with both video cable and S- VIDEO cable.

If connecting a DVD player to the TV with a component video cable.

Connect three jacks (Y, Cb/Pb, Cr/Pr) in the VIDEO-2 or VIDEO-3 terminal and the DVD player’s COMPONENT (component video output) jacks with a component video cables, instead of connection with a video cable. Then set the VIDEO-2 SETTING/ VIDEO-3 SETTING to COMPONENT, according to “VIDEO-2 SETTING/VIDEO-3 SETTING” on page 33.

If you have a DVD player that outputs 1125i, 625p or 525p video signals as a component video signal, then by attaching the device to the television with a component video cable you can see the actual images that are recorded on a DVD disc as an original image source.

If connecting a device to the VIDEO-2 (COMPONENT) or VIDEO-3 (COMPONENT) terminal with a video cable.

Connect the TV’s VIDEO jack and the device’s VIDEO OUT (video output) jack with a video cable.

Then set the VIDEO-2 SETTING or VIDEO- 3 SETTING to VIDEO according to “VIDEO-

2SETTING/VIDEO-3 SETTING” on page 33.

In the VIDEO-4 terminal, the VIDEO jack is indicated by “V”.

2Connect the TV’s AUDIO jacks (L/ MONO and R) and the device’s AUDIO OUT (audio L/R output) jacks with an audio cable.

If the device’s sound output is in mono: Connect the device’s AUDIO OUT jack and the TV’s L/MONO jack with an audio cable.

Connecting devices to the OUTPUT terminal

The signals of the images and sound you are currently viewing with this TV are output through the OUTPUT terminal. By connecting a VCR to the OUTPUT terminal, you can record the currently shown image and sound to that VCR. To do this, connect the VCR and OUTPUT terminal following the steps below.

1Connect the VIDEO jack in the OUTPUT terminal and the VCR’s VIDEO IN (video input) jack with a video cable.

2Connect the AUDIO jacks (L and R) in the OUTPUT terminal and the VCR’s AUDIO IN (audio L/R input) jacks with an audio cable.

When you turn off the TV, the signals from the OUTPUT terminal are also turned off.

The component signals input from the VIDEO-2 (COMPONENT) or VIDEO-3 (COMPONENT) terminal cannot be output through the OUTPUT terminal.

37

Page 81
Image 81
JVC HV-Z29V1, HV-Z34L1, HV-Z34L1, HV-Z29L1 specifications Connecting methods