JVC KD-AVX1 service manual Short-circuit points

3.2DVD mechanism assembly

3.2.1Removing the mechanism control board (See Fig.1)

Caution:

Before disconnecting the flexible wire extending from the DVD pickup, solder the short-circuit point on the flexible wire using a grounding soldering iron. If you do not follow this instruction, the DVD pickup may be damaged.

(1)	Turn over the body, and solder the short-circuit points on
	the flexible wire extending from the DVD pickup.
(2)	Disconnect the flexible wire from connector CN101 on the
	mechanism control board.
(3)	Disconnect the card wire from connector CN201 on the
	mechanism control board.
(4)	Disconnect the flexible wire from connector CN202 on the
	mechanism control board.
(5)	Unsolder two soldered points a on the mechanism control
	board and remove the wire extending from the feed motor.

Flexible wire		Lug wire
	A	B	Feed motor
Double tape

a

CN101

(6)	Remove the screw A attaching the lug wire.
(7)	Remove the two screws B and screw C attaching the
	mechanism control board.

Caution:

B

C

•As the flexible wire to be connected to CN101, make sure to attach it to the mechanism control board using a double tape.

•After reassembling, unsolder the short-circuit points.

Short-circuit points

CN201 CN202

Mechanism control board

Fig.1

(No.MA165)1-17