3.2.6Removing the front unit (See Fig.10 to 12)
•Remove the top cover and the mechanism section.
(1)Disconnect the flexible wire from connector CN202 on the mechanism control board at the bottom of the body. (See Fig.10.)
(2)Remove the screw G attaching the front unit on the top of the body. (See Fig.11.)
(3)Move the front unit toward the front to release joint h, and release two joints i and j on the right side of the chassis base assembly. Then remove the front unit upward. (See Figs.11 and 12.)
(4)Remove the two screws H attaching the switch board. (See Fig.12.)
Reference:
You can remove the switch board only without removing the front unit.
Caution:
G
Front unit
When reassembling, attach the flexible wire extending from the switch board using the double tape. (See Figs.10 and 12.)
Mechanism control board
Double tape
CN202
Flexible wire
Fig.10
Double tape
j
i
h
Fig.11
H
Switch board
Front unit G
h
Fig.12
