To select the external component to use
—EXT INPUT
You can connect the external component to the CD changer jack on the rear using the Line Input Adaptor
To use the external component as the playback source through this unit, you need to select which component — CD changer or external component — to use. When shipped from the factory, “CHANGER” is selected as the external component.
• CHANGER:
• LINE INPUT:
To make the front panel look flat (hiding the control panel) — FLAT PANEL
When operating the receiver using the remote control, you can hide the control panel to make the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected. |
| |
• FLAT ON: | The control panel will not | |
| come out when you turn on | |
| the unit. |
|
| To use the control panel, | |
| press 4 | so that the |
| control panel comes out. If no | |
| operation is done for about | |
| 10 seconds, it automatically | |
| goes back into the receiver. | |
• FLAT OFF: | You can use the control panel | |
| normally. |
|
Note:
When “FLAT ON” is selected, you can eject a CD by holding 4 .
To change the FM tuner selectivity
—IF FILTER
In some areas, adjacent stations may interfere with each other. If this interference occurs, noise may be heard. This unit has been preset to automatically reduce this interference noise (“AUTO”) when shipped from the factory.
• | AUTO: | When this type of interference |
|
| occurs, this unit automatically |
|
| increases the tuner selectivity |
|
| so that interference noise will |
|
| be reduced. (But the stereo |
|
| effect will also be lost) |
• | WIDE: | Subject to the interference |
|
| from adjacent stations, but |
|
| sound quality will not be |
|
| degraded and the stereo |
|
| effect will not be lost. |
To turn the demo mode on or off
—DEMO MODE
You can turn the demo mode on or off. When shipped from the factory, “DEMO ON” is selected.
• DEMO ON:
• DEMO OFF:
Note:
If the unit has been reset (and the power is on), demonstration will start if no sound comes in for
about 10 seconds.
ENGLISH
25