| Manual preset | |
ENGLISH | ||
You can preset up to 6 stations in each band (FM1, | ||
| ||
| FM2, FM3 and AM) manually. | |
| Ex.: Storing an FM station of 88.3 MHz into the | |
| preset number 1 of the FM1 band | |
|
|
1 Select the band (FM1).
1Press SOURCE to select FM as the source.
2Press and hold MODE
BAND
BAND repeatedly to select the FM1 band.
2 Tune into a station of 88.3 MHz.
Press 
¢ to tune into 
stations of higher frequencies.
Press 4 
to tune into stations of lower frequencies.
3 Press and hold the number button (in this example, 1) for more than 2 seconds.
Band number and “MEMO” appear alternately for a while.
10
4 Repeat the above procedure to store other stations into other preset numbers.
Notes:
•A previously preset station is erased when a new station is stored in the same preset number.
•Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.
Tuning into a preset station
You can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 9 and 10.
1 Select the band.
1Press SOURCE to select
FM or AM as the source.
2If necessary, press and
BAND | hold MODE BAND to |
| |
| select the FM band |
| number (FM1, FM2 or |
| FM3). |
Each time you press and hold the button, the FM band changes as follows:
FM1 
FM2 
FM3
2 Select the number (1 – 6) for the preset station you want.
If the sound quality decreases and the stereo effect is lost while listening to an FM station
In some areas, adjacent stations may interfere with each other. If this interference occurs, this unit can automatically reduce this interference noise (the initial setting when shipped from the factory). However, in this case, the sound quality will be degraded and the stereo effect will be also lost.
If you do not want to degrade the sound quality and to lose the stereo effect, rather than to eliminate the interference noise, see “To change the FM tuner selectivity — IF FILTER” on page 26.
