To adjust the display contrast level
—CONTRAST
You can adjust the display contrast level among “01” (dark) to “10” (bright). When shipped from the factory, the display contrast level is set at level “05.”
To select the scroll mode — SCROLL MODE
You can select the scroll mode for the disc information if it consists of more than 12 characters. When shipped from the factory, Auto Scroll mode is set to “SCROLL ONCE.”
•SCROLL ONCE: Scrolls only once.
•SCROLL AUTO: Repeats the scroll
(in
• SCROLL OFF: Cancels Auto Scroll.
Note:
Even if the scroll mode is set to “SCROLL OFF,” you can scroll the display by pressing DISP for more than 1 second.
To select the subwoofer cutoff frequency
—WOOFER FREQ
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to “FREQ
MID.” |
|
• FREQ LOW: | Frequencies higher than |
| 50 Hz are cut off to the |
| subwoofer. |
• FREQ MID: | Frequencies higher than |
| 80 Hz are cut off to the |
| subwoofer. |
• FREQ HIGH: | Frequencies higher than |
| 120 Hz are cut off to the |
| subwoofer. |
To adjust the line input level — LINE ADJ
Adjust the line input level properly when an external component is connected to the LINE IN plugs. When shipped from the factory, the line input level is set at level “00.”
If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change from the external component to another source.
To make the front panel look flat (hiding the control panel) — FLAT PANEL
When operating the receiver using the remote control, you can hide the control panel to make the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected. |
| |
• FLAT ON: | The control panel will not | |
| come out when you turn on | |
| the unit. |
|
| To use the control panel, | |
| press 4 | so that the |
| control panel comes out. If no | |
| operation is done for about | |
| 10 seconds, it automatically | |
| goes back into the receiver. | |
• FLAT OFF: | You can use the control panel | |
| normally. |
|
Note:
When “FLAT ON” is selected, you can eject a CD by holding 4 
.
ENGLISH
25
