ENGLISH
Assigning names to the sources
You can assign names to CDs and the external component connected to the LINE IN plugs. After assigning a name, it will appear on the display when you select the source.
Sources | Maximum number of |
| the characters |
|
|
CDs* and | Up to 32 characters (up to |
CD changer* | 40 discs) |
External component Up to 12 characters
*You cannot assign a name to a CD Text.
1 Select a source you want to assign a name to.
3 Select the character set you want while “ 
” is flashing.
Each time you press the button, the
character set changes as follows:
Capital letter ( 
)
Small letter ( 
)
Numbers and symbols ( 
) 
4 Select a character.
About the available characters, see page 29.
2 Press and hold SEL (select) for more than 2 seconds while pressing DISP.
When you select the CD as the source:
When you select the external component connected to LINE IN as the source:
5 Move the cursor to the next (or previous) character position.
6 Repeat steps 3 to 5 until you finish inputting the name.
7 Press the button while the last selected character is flashing.
The input name is stored in memory.
To erase the input characters
Insert spaces using the same procedure
described above.
28
