JVC KD-SH9102 Selecting a preset station using the preset station list, Initial display pattern

ENGLISH

Selecting a preset station using the preset station list

If you forget what stations are stored in what preset numbers, you can check the preset station list, then select your desired station on the list.

1 Select the band (FM1 – 3, AM).

Changing the display pattern

By pressing DISP (D), you can change the information shown on the display.

Each time you press the button, the

Ddisplay patterns change as follows:

DISP

SRC

AM FM1

FM3 FM2

1Press SRC (source) repeatedly to select the tuner.

2Press and hold SRC for more than 1 second.

3Within about 5 seconds, press SRC again.

Each time you press the button, the band changes.

•Initial display pattern:

*1 *2

2 Press and hold 5(up) or ∞(down) until the preset station list for the current band (FM1, FM2, FM3, or AM) appears on the display.

The currently received station will

be highlighted on the display.

•Programme station (PS) name is

emphasized:*3

*1 “No Name” always appears for AM or FM non-RDS stations (see the following pages).

*2 Appears only when selecting a preset station. *3 PTY code appears only when receiving an RDS

station.

Notes:

•If one of FM band preset station lists (FM1, FM2, or FM3) is shown on the display, you can show the other lists by pressing 5 (up) or ∞(down).

•If a preset station is an FM RDS station with PS signal, PS name will be shown instead of the station frequency.

3 Select the number (1 – 6) for the preset station you want.

1 2 3 4 5 6

14