JVC KD-SH9105 manual Assigning names to the sources, English, To erase the entered characters

ENGLISH

Assigning names to the sources

You can assign names to station frequencies, CDs (both in this unit and in the CD changer), and the external component.

After assigning a name, it will appears on the display when you select the source.

Sources	Maximum number of
	characters
Station frequencies	Up to 10 characters (up to
	30 station frequencies
	including both FM and
	AM)
CDs*	Up to 32 characters (up to
	40 discs)
External component	Up to 8 characters

*You cannot assign a name to CD Text, MP3, and WMA discs.

.

1 Select a source you want to assign a name to.

SRC When you select a source, the

power automatically comes on.

2 While holding DISP (D), press and hold SEL (select) for more than 2 seconds.

SEL

D

DISP

3 Select the character set you want while the first character position is flashing.

Each time you press the button,

Dthe character set changes as

DISPfollows:

(A – Z: capital) (a – z: small)

(0 – 9: numbers, and symbols)

4 Select a character.

• About the available

ATT characters, see page

55.

5 Move the cursor to the next

(or previous) character position.

6 Repeat steps 3 to 5 until you finish entering the name.

7 Finish the procedure while the last selected character is flashing.

SEL

Ex.: When you select an FM station as the source

To erase the entered characters

Insert spaces using the same procedure described above.

Notes:

•When you try to assign a name to the 41st disc or to the 31st station frequency, “Name Full” appears and you cannot enter the text entry mode. In this case, delete unwanted names before assignment.

•When the CD changer is connected, you can assign names to CDs in the CD changer. These names can also be shown on the display if you insert the CDs in this unit.

44