JVC KS-FX725R service manual Disassembling the flywheel assembly F See, Removing the reel board

KS-FX725R

Disassembling the flywheel assembly (F) (See Fig.22 and 23)

1.Push and turn counterclockwise the spring holder (F) to release the three joints s on the bottom of the flywheel.

2.The spring holder (F), the TU spring and the friction gear play come off.

3.Remove the polywasher and felt.

Disassembling the flywheel assembly (R) (See Fig.22 and 24)

1.	Push and turn clockwise the spring holder (R) to
	release the three joints t on the bottom of the
	flywheel.
2.	The spring holder (R), the FF spring and the friction

Flywheel assembly (F)

Joints s

Joint s

Fig.22

Flywheel assembly (R)

Joints t

Joint t

gear FF come off.

3. Remove the polywasher and the felt.

Removing the reel board

Polywasher

Polywasher

Spring holder (R)

Spring holder (F)

(See Fig.25 and 26)

TU spring

FF spring

1.Remove the two screws E attaching the reel board.

2.Move the reel board in the direction of the arrow to release the joint u.

3.Unsolder the wires if necessary.

CAUTION: When reattaching, confirm operation of the MODE switch and the ST-BY switch.

The mode position between EJECT and

ST-BY is optimum for reattaching.

Connect the card wire extending from the reel board to the FFC pad before reattaching the reel board.

FFC pad

E

Joint u

Reel board

E

Fig.25

Friction gear FF

Friction gear play

Felt

Felt

Flywheel assembly (F) Flywheel assembly (R)

Fig.23 Fig.24

FFC pad

CT-1 switch

MODE switch

Soldering

ST-BY switch

Fig.26

1-12