EN 43

G Set the tape speed.

For the VHS deck

Press SP/EP (p).

For the DV deck

Press SP/LP (p).

H Return to the normal screen.

Press PROG or OK. “PROGRAM COMPLETED” appears on the TV screen for about 5 seconds, then the normal screen appears. If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears on the TV screen, see page 51.

Repeat steps 3 8 for each additional program.

I Engage the VCR’s timer mode.

Press TIMER. The VCR turns off automatically and “#” appears on the front display panel.

To disengage the timer mode, press TIMER again.

Cable Box or DBS Receiver Users

To timer-record a cable or satellite broadcast using the VCR plus+ system:

APerform “Cable Box Control Setting” ( pg. 20) or “DBS Receiver Control Setting” ( pg. 23).

BPerform steps 1 9.

CLeave the power of cable box or DBS receiver on.

IMPORTANT

If you have moved to a different area or if a broadcasting station's channel number has been changed, the wrong VCR CH or CABLE CH number will be displayed on the VCR Plus+ program screen in step 6. When this happens, set the correct Guide Channel number for that station. ( pg. 44, “Changing VCR Plus+® Setting”)

NOTES:

To Change The Stop Time . . .

. . . press STOP +/– in step 6. You can compensate for anticipated program schedule delays.

To Timer-Record Weekly Or Daily Serials . . .

. . . in step 6, press WEEKLY (number key 9”) for weekly serials or DAILY (M–F) (number key 8”) for daily serials (Monday — Friday). Either “WEEKLY” or “DAILY” appears on the TV screen. Pressing the button again makes the corresponding indication disappear.

In case of a power failure after programing, the VCR’s memory backup keeps your selections for approximately 10 minutes.

You can program each deck to timer-record as many as 6 programs. If you try to program the VCR to record a seventh, “PROGRAM FULL” appears on the TV screen. To record the

extra program, you must first cancel any unnecessary programs ( pg. 50).

It is not possible to timer-record the same program on both the VHS deck and the DV deck simultaneously.

During timer recording, it is not possible to change the recording deck (VHS or DV).

If the times that are programed for recording on the DV deck and on the VHS deck overlap, the earlier start time takes precedence. If the start times are the same, the VHS deck takes precedence.

ATTENTION

Guide Channel Number Set

“GUIDE CHANNEL SET” appears after performing step 6 if the Guide Channel number for the PlusCode number you entered has not been set.

If you want to set the Guide Channel number for the TV or cable station, press number keys or rtto input the channel position number on which your VCR or cable box receives that station, then press OK or e to set the Guide Channel number. VCR Plus+ Program screen appears.

If you receive your channels with a cable box and if you have properly set your Controller, “CABLE CH” appears in place of “VCR CH”. If not, refer to pages 20.

Page 43
Image 43
JVC LPT0641-001A manual Engage the VCR’s timer mode, For the VHS deck, For the DV deck, Cable Box or DBS Receiver Users