JVC LPT0641-001A manual Enter the program date, Enter the channel position, Press DATE+, Press CH+

EN 47

H Enter the program date.

Press DATE+/–.

●The current date appears on the TV screen. The date you enter appears in its place.

I Enter the channel position.

Press CH+/–.

●If you are using a DBS receiver, see “ATTENTION FOR DBS RECEIVER USERS” in the right column.

●Holding down CH +/– rapidly scans through the channels.

J Set the tape speed.

For the VHS deck

Press SP/EP (p).

For the DV deck

Press SP/LP (p).

K Return to the normal screen.

Press PROG or OK. “PROGRAM COMPLETED” appears on the TV screen for about 5 seconds, then the normal screen appears. If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears on the TV screen, see page 51.

●Repeat steps 3 – 11 for each additional program.

L Engage the VCR’s timer mode.

Press TIMER. The VCR turns off automatically and “#” appears on the front display panel.

●To disengage the timer mode, press TIMER again.

NOTES:

●To Timer-Record Weekly Or Daily Serials . . .

. . . anytime during steps 5 through 10, press WEEKLY

(number key “9”) for weekly serials or DAILY (M–F) (number key “8”) for daily serials (Monday – Friday). Either “WEEKLY” or “DAILY” appears on the TV screen. Pressing the button again makes the corresponding indication disappear.

●You can program each deck to timer-record as many as 6 programs. If you try to program the VCR to record a seventh, “PROGRAM FULL” appears on the TV screen. To record the

extra program, you must first cancel any unnecessary programs ( pg. 50).

●In case of a power failure after programing, the VCR’s memory backup keeps your selections for approximately 10 minutes.

●Programs that start after midnight must have the next day’s date.

●You can program the timer while a regular recording is in progress; the on-screen menu will not be recorded.

●It is not possible to timer-record the same program on both the VHS deck and the DV deck simultaneously.

●During timer recording, it is not possible to change the recording deck (VHS or DV).

●If the times that are programed for recording on the DV deck and on the VHS deck overlap, the earlier start time takes precedence. If the start times are the same, the VHS deck takes precedence.

Cable Box or DBS Receiver Users

To timer-record a cable or satellite broadcast using Express Timer Programing:

APerform “Cable Box Control Setting” on page 20 or “DBS Receiver Control Setting” on page 23.

BPerform steps 1 – 12.

CLeave the power of cable box or DBS receiver on.

ATTENTION FOR DBS RECEIVER USERS

If you are using a DBS receiver (unless “DBS RECEIVER SET” is set to “OFF”  pg. 24), the band indication (TV, CATV or DBS) appears under the channel number indication.

TV: To timer-record a regular TV broadcast received

on the VCR. CATV: To timer-record a cable

TV broadcast received on the VCR, or through a

cable box (unless “CABLE BOX SET” is set

to “OFF”  pg. 21).

DBS: To timer-record a satellite broadcast received through a DBS receiver.

NOTE:

If “BAND” is set to “TV” on the Tuner Set screen ( pg. 18) and “CABLE BOX SET” is set to “OFF” on the Cable Box Set screen ( pg. 21), “CATV” will not be displayed on the Program screen; If “BAND” is set to “CATV” or “CABLE BOX SET” is set to “ON”, “TV” will not be displayed.

If the channel number entered requires that the band be set, “7=DBS” is displayed on the screen.

If this happens, press the number key “7 (DBS)” to select “DBS”.