Masterpage:Right0
Filename [DR-M1EK_10Editing.fm]
Page 87 August 15, 2003 7:53 pm
87
REMOTE CONTROL
Remote Control Functions

Remote 1/2/3/4 Code Switching

The remote control is capable of controlling four JVC video units
independently. Each of the units can respond to one of four
codes (1, 2, 3 or 4). The remote control is preset to send 1 code
signals because your unit is initially set to respond to 1 code
signals. You can easily modify your unit to respond to 2, 3 or 4
code signals.
On the remote control
Keep pressing SET UP down during steps AB.
AChange the remote control code.
Press the number key “1” for 1, “2” for 2, “3” for 3 or
“4” for 4.
BSet the remote control code.
Press ENTER to set the code.
On the unit
CTurn off the unit.
Press 1 on the unit.
DDisplay the code.
Press 4 on the unit for over 5 seconds while the unit is
turned off.
The code currently set appears on the front display panel.
EChange the unit’s code.
Press 8 on the remote control.
The code currently set on the remote control blinks on the
front display panel for approximately 5 seconds, and is
applied to the unit.
NOTE:
When “POWER SAVE” is set to “ON” (pg.95), it is not
possible to change the remote code.
Slide the TV/CABLE/SAT/DVD switch to DVD.
DR-M1EK_01.book Page 87 Friday, August 15, 2003 7:53 PM