58

TIMER RECORDING (cont.)

Manual Timer

Programming

You can programme this unit to timer-record as many as 8 programmes.

If you do not know the PlusCode number for the programme you wish to record, use the following procedure to set your unit to timer-record the programme.

Before performing Manual Timer Programming:

Turn on the unit.

Turn on the TV and select the AV mode.

Slide the TV/CABLE/SAT/DVD switch to DVD.

Make sure that the unit’s built-in clock is set properly.

A Load a disc.

APress x to open the disc tray.

BPlace a recordable disc on the disc tray.

For details, refer to “Placing a Disc” ( pg. 10).

CPress x to close the disc tray.

B Access Programme Check screen.

Press PROG/CHECK.

When “PROGRAMME FULL DELETE UNWANTED TIMER PROGRAMME” appears on the TV screen, you need to cancel some of the reserved programmes. ( pg. 63)

C Access the programme screen.

Press rt repeatedly to select “NEW TIMER PROGRAMME”, then press

ENTER.

D Enter the recording date.

Press rt repeatedly to set the desired date.

The current date appears on the TV screen. The date you enter appears in its place.

E Enter the recording start time.

Press w e to select “START”, then press rt repeatedly to set the desired start time.

Each press of rt advances/goes back the start time in 1-min. increments.

To advance/go back the start time in 30-min. increments, press and hold rt.

Page 58
Image 58
JVC LPT0827-001B, DR-M1SLB manual Manual Timer Programming, Access Programme Check screen, Access the programme screen